Management and Configuration Guide (Includes ACM xl) 2005-12

ProCurve Secure Access 700wl Series Management and Configuration Guide A-15
Bridging is enabled
Configured bridges:
cdp: ether [12:2] <= 1514 and ether dst 01:00:0c:cc:cc:cc
wnmp: ether [12:2] = 0x8781 and ether[0:4] = 0x01a0f8f0
custom: ether[12:2] = 0x8037 or ether[12:2] = 0x8137
show clientprobes
Displays the current configuration of the client probe timers. Output from this command is similar
to the following:
Client probes
Interval: 30 seconds of idle time
Timeout: 300 seconds of idle time
show forwardipbroadcasts
Shows the list of ports or slots and ports that have IP broadcast forwarding enabled. For example,
output from this command for an Access Controller or Integrated Access Manager with 12 ports
appears as follows:
Enabled on: 1/1 1/2 1/3 1/4 2/1 2/2 2/3 2/4 3/1 3/2 3/3 3/4
Access Control Server Configuration
With two exceptions, the following commands are available only on a Access Control Server, or on an
Integrated Access Manager in
cli acs mode. The exceptions are the show syslogserver and show natdhcp
commands, which are also available on an Access Controller.
show ac [mac <mac-address>]
Shows Access Controller settings for one or all Access Controllers connected to the Access Control
Server or Integrated Access Manager. The default is to show all settings for all Access Controllers.
The
show ac command with no parameters shows basic information about the connected Access
Controllers, including the length of time they have been running and the software version
currently running and the length of time the unit has been up.
enable redundancy
Enables Access Control Server failover in the 700wl Series system. Redundancy (failover) will be
enabled with the current parameters. These can be displayed by using the command
show
redundancy
. The parameters can be set using set redundancy.
Note:
If you set a redundant peer IP address, there is a seven second configuration change delay
before the change takes effect. If you try to enable redundancy before seven seconds have elapsed,
the enable command will fail with a message that no peer is specified.
disable redundancy
Disables the redundancy system.
mac <mac-address> Specifies the MAC address of an Access Controller