Management and Configuration Guide (Includes ACM xl) 2005-12

ProCurve Secure Access 700wl Series Management and Configuration Guide A-21
set l2tp on | off
Enables or disables L2TP.
set ipsecsecret [ <secret> <secret>]
Sets the IPSec shared secret. Prompts for the secret if not entered on the command line.
clear ipsecsecret
Clears the IPSec shared secret.
set espencryption [des] [3des] [blowfish] [cast] [aes] [none]
Sets the IPSec ESP encryption methods. You must specify at least one method.
set espintegrity [md5] [sha1] [none]
Set the IPSec ESP integrity methods. You must specify at least one method.
set ikedh [group1] [group2] [group5]
Set the IPSec IKE Diffie-Hellman groups. You must specify at least one group.
set ikeencryption [des] [3des] [blowfish] [cast]
Set the IPSec IKE encryption methods. You must specify at least one method.
set ikeintegrity [md5] [sha1]
Set the IPSec IKE integrity methods. You must specify at least one method.
set ipsec on | off
Enables or disables IPSec.
set initialcontact on | off
Enables or disables IPSec initial contact messages to clients. Enabled by default.
set ssh on | off
Enables or disables ssh for encryption.
show encryption
Note: Even though you can only configure encryption settings from the Access Control Server or
Integrated Access Manager, you can use the show encryption command from an Access Controller
to view these settings.
Shows the current encryption settings. Output from this command is similar to the following:
IPSec: Disabled