Management and Configuration Guide (Includes ACM xl) 2005-12

ProCurve Secure Access 700wl Series Management and Configuration Guide A-35
set snmplocation <location>
Sets the SNMP sysLocation object defined in RFC 1213 as “the physical location of this node (for
example, telephone closet, 3rd floor).”
Note:
You cannot set this object from an external manager via SNMP.
clear snmplocation
Clears the SNMP sysLocation object.
Note:
You cannot clear this object from an external manager via SNMP.
set snmpcontact <contact>
Sets the SNMP sysContact object, defined in RFC 1213 as “the textual identification of the contact
person for this managed node, together with information on how to contact this person.”
Note:
You cannot set this object from an external manager via SNMP.
clear snmpcontact
Clears the SNMP sysContact object.
Note:
You cannot clear this object from an external manager via SNMP.
set snmpcommunity <community>
Sets the SNMP read community string. The default is public. HP strongly recommends that you
change the community string. This is also used for traps.
clear snmpcommunity
Clears the SNMP community string.
add snmptrapreceiver <ip-address>
Specifies an IP address to receive traps.
You can specify two trap receivers, by executing this command twice. If you try to specify a third
trap receiver, you will receive an error message.
delete snmptrapreceiver all | <ip-address>
Deletes a specified trap receiver, or both trap receivers.
set snmpauthtraps on | off
Enables or disables the generation of authentication traps.