Management and Configuration Guide (Includes ACM xl) 2005-12

A-36 ProCurve Secure Access 700wl Series Management and Configuration Guide
show snmp
Note: Even though you can only configure SNMP for an Access Controller from a Access Control
Server or Integrated Access Manager, you can use the show snmp command from an Access
Controller to view the SNMP settings.
Shows the current SNMPv1 configuration. Output is similar to the following example:
SNMP: Disabled
SNMP Access Mode: Read Only
Community Name: public
SNMP Port: 161
Location: ServerCloset Bldg2
Contact Info:
Device Name: 192.168.10.174
Authentication Traps: Enabled
Trap IP Address: None
Authorized Managers: None