Management and Configuration Guide Wireless Edge Services xl Module Supplement 2007-06

5300xl Switch Support for the Wireless Edge Services xl Module

are enabled by default and allow radio ports connected directly to PoE-

enabled 5300xl switch ports to communicate with the Module without any

manual configuration,

Use the show lldp auto-provision radio-ports command to display the settings

and status of auto-provisioning by the switch.

Radio ports connected to infrastructure switches also can use the Auto-VLAN,

but this requires manual configuration of the Auto-VLAN and proper port

VLAN membership assignments (downlink radio port (unless 802.1X RADIUS-

assigned VLANs does so) and a network uplink port to the wireless services-

enabled switch) in the infrastructure switches. It is recommended that any

infrastructure switches be members of a management VLAN that includes the

Wireless Services-Enabled Switch 5300xl, to simplify this manual configura-

tion.

The auto-provision LLDP command enables or disables auto-provisioning by

the switch (enabled by default). The action taken by the switch when a Module

or radio port is detected or removed depends on the state of auto-provisioning

(enabled or disabled) and the existence and port membership of the Auto-

VLAN. This behavior is described in Table 1. Note: in the table below, the state

Auto-Provision means auto-provisioning is enabled; No Auto-Provision means

auto-provisioning is disabled. Also, Auto-VLAN means an Auto-VLAN is config-

ured on the switch; No Auto-VLAN means that there is no Auto-VLAN config-

ured.

ProCurve(config)# show lldp auto-provision radio-ports

LLDP auto-provision Radio-Ports Support:

LLDP Radio Port Enable [Yes] : Yes

LLDP Radio Port suggested auto-vlan [2100] : 120

LLDP Radio Port auto-vlan : 2100

LLDP Radio Port assigned ports : C1,C23

LLDP Global Enable [Yes] : Yes

ProCurve(config)#