Management and Configuration Guide Wireless Edge Services xl Module Supplement 2007-06

23
Configuring the Module on the Network
Displaying the Module’s Software Version
In versionWS.02.xx (or greater), use the show wireless-services <slot-id> com-
mand to display Module’s software version. The following example shows a
Module running software version WS.02.02:
Configuring the Module on the Network
By default, the Module uses DHCP to get an IP address. When the IP address
is assigned manually be sure to configure the Default gateway: if it is needed.
Use the following commands to configure an IP address manually.
Note ‘ProCurve’ is used here as a generic prompt for all 5300xl switches.
ProCurve # wireless-services <slot-id>
where <slot-id> is the slot in the 5300xl where the Module is installed.
ProCurve(wireless-services-<slot-id>)#configure
ProCurve(wireless-services-<slot-id>)(config)#interface vlan1
ProCurve(wireless-services-<slot-id>)(config-if)# ip address <IP>
where <slot-id> is the slot in the 5300xl where the Module is installed.
where <IP> is the IP address in CIDR notation (/mask bit number) or
dhcp which uses a DHCP client to obtain an IP address.
ProCurve> show wireless-services a
Status and Counters - Wireless Services Module A Status
HP Wireless Services XL Module J9001A
Versions : A.01.02, B.01.01, WS.02.02
Current status : running
Uplink MAC address : 0001e6-f586fd
For more information, use the show commands in wireless-services context
ProCurve>