Management and Configuration Guide Wireless Edge Services xl Module Supplement 2007-06

24
Configuring the Module on the Network
If necessary, use the following command in the Config context to set or change
the default gateway:
ProCurve(wireless-services-B)(config)#ip default-gateway <ip-addr>
where <ip-addr> is the numeric IP address of the default gateway, for
example 10.1.2.1.
To display the Module’s IP address, you must first go to the wireless services
context in the 5300xl CLI, using the following command:
ProCurve # wireless-services <slot-id>
To show the Module’s IP address, enter
ProCurve(wireless-services-id)# show ip interfaces
The following example shows the IP address assigned by DHCP to a Module
installed in Slot B of a 5300xl switch:
Changing the Auto-Provision VLAN-Base
You may wish to use another VLAN as your suggested Auto-VLAN. This may
be done using the following command.
ProCurve (Config)# lldp auto-provision radio-ports vlan-base <vid>
where <2-4094> is the suggested VLAN ID (VID) used when the Auto-
VLAN is created by LLDP auto-provisioning.
The following command changes the vlan-base used when the Auto-VLAN is
created to 120 instead of the default 2100.
ProCurve (Config)# lldp auto-provision radio-ports vlan-base 120
The show lldp auto-provision radio-ports command displays the new configura-
tion of the vlan-base.
ProCurve(wireless-services-B)#show ip interface
Interface IP-Address Status Protocol
vlan1 10.100.50.10(DHCP) up up
vlan21 10.10.10.10 up up
ProCurve Switch 5304XL(wireless-services-B)#