Management and Configuration Guide Wireless Edge Services xl Module Supplement 2007-06

29
Management Interfaces
Syntax: [no] lldp auto-provision radio-ports auto-vlan <vid>
Creates the Auto-VLAN with the specified VLAN ID
(VID) if it does not already exist and if the specified
VID does not already exist.
If the radio port Auto-VLAN already exists, all ports in
the current Auto-VLAN are moved to the new Auto-
VLAN. If the previous Auto-VLAN then contains only
downlink ports (<slot-id>DP) or is empty, it is deleted.
The no lldp auto-provision radio-ports auto-vlan <vid> com-
mand may be used to delete the auto-vlan.
Syntax: lldp auto-provision radio-ports vlan-base <2-4094>
Sets the suggested Auto-VLAN’s ID (VID) for the Auto-
VLAN created by the switch when a Wireless Edge
Services xl Module or radio port is discovered and auto-
provisioning is enabled (the default). If the VID is
already in use, the next available VID following the
suggested value is used.
The default suggested VID is 2100.
Syntax:
wireless-services <slot-id>
Changes the CLI to the wireless-services context for the
Wireless Edge Services xl Module in slot-id (a - h). The
exit command returns the CLI to the switch configura-
tion context.
Syntax: wireless-services <slot-id> reload]
Reboots the wireless services Module in slot-id with the
current software version. This command may be used
to restart a Module that was previously shutdown
Syntax: wireless-services <slot-id> shutdown]
Halts the wireless services Module in slot-id.