ONE Services zl Module Installation and Getting Started Guide 2009-01

C-8
Hardware Components
Replacing the Flash Card
1. Using either a flat-bladed or Torx T-10 screwdriver loosen the retaining
screws securing the module.
2. Using the extractor handles, pull the module out from the slot and turn
it over.
3. Slide out the old flash card by applying slight pressure to the top of the
flash card.
4. Position the new flash card properly and slide it in being careful not to
bend any connector pins.
5. Re-install the module into the switch.
6. Use an equal amount of pressure and push both extractor handles closed
to completely seat the module.
7. Tighten the retaining screws.
Figure C-6. Steps to Replacing the Module’s Flash Card
1. 2.
3. 4.
Retaining Screws
Extractor Handles
zlSM .book Page 8 T hursday, January 29, 2009 11:53 AM