PCM+ Agent with ONE zl Module Installation and Getting Started Guide 2009-11

1-8
Getting Started
Setup
Verify the Services zl Module OS Version
The ONE Services zl Module must be running Services OS software version
1.0.081219 or greater. To view the software version, complete the following
steps:
1. From either the manager-level or the global configuration context of the
host switch’s CLI, enter the following command to move to the Services
OS context:
hostswitch# services <slot id> 1
2. At the Services OS prompt, enter the following command:
hostswitch (services-module-C:HD)# show version
The output shows the versions of all images stored on the module, both
on the hard disk (HD) and compact flash (CF). The output should look
similar to the following.
-------------- ServiceOS -----------------
J9154A ServiceOS version 1.0.081219
Description: HD Service OS
Build Date: Nov 14 2008 18:24
Components: TOOLS.0.081219 HDSOS.0.081219
If a software update is needed, follow the instructions provided in ProCurve
Switch ONE Services zl Module Installation and Getting Started Guide,
available on the Web at www.hp.com/go/procurve/manuals.
Installing the PCM+ Agent Application
If you are using an HP ProCurve PCM+ Agent with ONE zl Module (J9496A),
you should skip to “Activating the PCM+ Agent Application” on page 1-12.
Using the Service OS CLI, you can install an application either through the
module’s USB interface or over the network using FTP. Each method is
described below.
Using the USB Interface to Install the Application
Complete the following steps:
1. Download the PCM+ Agent Application from the following location:
http://www.procurve.com/one/applications/pcmplus.htm