PCM+ Agent with ONE zl Module Installation and Getting Started Guide 2009-11

1-16
Getting Started
Setup
3. You will be returned to the host switch’s CLI. If you want to view the
progress of the reboot process, enter the following commands in succes-
sion:
For example, if the ONE Services zl Module is in slot C, you would enter:
hostswitch# show services c
hostswitch# repeat
You will continue to see updated output for the show services command.
The following shows an example of the output you might see. The Current
status information will vary, depending on the progress of the boot pro-
cess.
Status and Counters - Services Module C Status
HP Services zl Module J9154A
Versions : A.01.06
Current status : booting
For more information, use the show commands in
services context
When the Current status is running as shown below, press any key to stop
the execution of the show services command.
Status and Counters - Services Module C Status
HP Services zl Module J9154A
Versions : A.01.06, B.01.03
Current status : running
For more information, use the show commands in
services context
Syntax: show services <slot ID>
Displays the current status of the module and the version
of the operating systems running on the module.
Replace <slot ID> with the letter of the chassis slot in which
the module is installed.
Syntax: repeat
Repeatedly executes the previous command you entered.