Read Me First for ONE Services zl Module 2008-07

Saving the Configuration After Installing or Exchanging a Module

The following cases automatically result in a change to the running-configuration on your switch:

■ If you replace a module with another module of a different type and then reboot the switch

■ If you install a module in a slot that has not previously been used (including when you install

a module and apply power to the switch for the first time)

If you want to save such changes to permanent memory (startup-configuration), use the write memory

command in the switch console. This causes the switch to use the new hardware configuration for

subsequent reboots. (The switch always reboots from the startup-configuration.)

If you do not save the hardware changes to the startup-configuration, you will be prompted with the

following message the next time you use the reboot or reload commands:

Do you want to save the current configuration [y/n]?

For more information on switch memory, including the startup-config and running-config memories,

refer to the Management and Configuration Guide for your switch.

For the latest version of this documentation, see "View or Download the Manual Set" above.

Development Company, L.P.

The information contained herein

is subject to change without notice.

Part Number: 5998-3246

March 2012

Printed in Singapore

*5998-3246*