Release Notes Threat Management Services zl Module ST.1.2.110427 06-2011

Known Issues

Release ST.1.1.100430

From the Windows system, the VPN client just returns an error message saying that the

connection was interrupted.

■ PR_63072 — RADIUS error messages generated on successful authentication for Windows

L2TP/IPsec VPN clients. This occurs on Windows XP, Windows Vista, and Windows 7. The

authentication error (for example, IAS Reason-Code IAS_NO_SUCH_USER) is caused by

the Windows VPN client first attempting to authenticate using the machine name. When that

fails, the Windows VPN client then attempts to authenticate using the actual user name,

which succeeds, and for which RADIUS shows a "success" message (for example, IAS

Reason-Code IAS_Success). The TMS zl Module logs show corresponding entries

reflecting both the initial authentication failure when machine name is provided followed

by the authentication success when the user name is provided.

Release ST.1.1.100430

The following problems are known issues as of release ST.1.1.100430.

General

■ PR_7645 — When using tab key and then going out the CLI session, unexpected behavior

occurs.

Note: this occurs only when using the switch CLI and going to the TMS module using the 'services'

command.

Steps:

1. Open a TMS CLI session using the 'services' command from the switch.

2. Execute command #configure

3. Press the tab key

4. When the Ctrl+C message is displayed press Ctrl+Z

5. Go back into the TMS CLI session using the 'services' command.

6. Execute command #configure

The command is executed but the tab command seems to be executed as well.

■ PR_45860 — In the web browser interface, if a manager is trying to login to a TMS using

FireFox and a manager is already logged into the web browser interface from another

machine, the user is notified that another manager is logged in, but the pop up dialog asking

to close the window is not displayed. Internet Explorer displays the dialog correctly.

■ PR_52768 — When logging in as operator in the web browser interface, the utilities page is

grayed out. As a result, an operator is not able to use the ping utility. However, when logging

in as an operator using an SSH session, the ping utility is available.