Release Notes Threat Management Services zl Module ST.1.2.110909 11-2011

Known Issues

Release ST.1.0.090213

■ PR_961 — The initial login banner text of the web browser interface in the TMS zl Module

differs in size depending on whether the user is accessing it with HTTP or HTTPS. While

noticeable, this difference in size does not impair functionality.

■ PR_1044 — From the TMS zl Module CLI, when a TMS zl Module is operating in Routing

Mode using OSPF, the command show ip ospf neighbor has an output that is not the same as

a HP E switch that is running OSPF. Important information about OSPF neighbors is still

shown, how the information that is shown is different from the switch.

■ PR_1143 — The options for VLAN IPv4 functionality change depending on how a command

is accessed. For example, vlan <id> ip options are different than going into the VLAN context

via vlan <id> and then typing ip.

Example:

HP Switch(tms-module-D:config)# vlan 20 ip

address Set IP parameters for communication within an IP network.

igmp Enable IGMP on the VLAN.

pim-sparse Enable PIM-SM on the device.

HP Switch(tms-module-D:config)# vlan 20

HP Switch(tms-module-D:vlan-20)# ip

address Set IP parameters for communication within an IP network.

igmp Enable IGMP on the VLAN.

rip Configure RIP on the VLAN.

ospf Configure OSPF settings.

pim-sparse Enables PIM-SM on the VLAN.

The impact to the user is that some commands cannot be typed in a single line and the VLAN

configuration context must be entered in order to configure some items.

■ PR_3186 — From the CLI, the schedule command does not auto-complete when the Tab

key is pressed as other commands from the command line do.

For example, the following command will not auto-complete to daily when the Tab key is pressed

after only dail is typed:

HP Switch(tms-module-D:config)#schedule time1 dail

The impact to the user is that the entire parameter must be typed out.

■ PR_4155 — The two internal Ethernet ports of the TMS zl Module have an actual speed of

10Gbps. However, in the SNMP MIB, they are reported as 10Mbps. This issue only affects the

reporting of the speed via SNMP. The actual speed is 10Gbps.

■ PR_4266 — There is a discrepancy between the web browser interface and the CLI in regards

to how the subnet mask is specified in a static route configuration. The CLI requires the

subnet mask to be specified in dotted decimal format while the web browser interface uses

CIDR addresses. No functionality is impacted.