Riverbed® Steelhead® RiOS® Application Installation and Getting Started Guide 2010-10
Table Of Contents
- 1: Overview
- 2: Hardware Installation
- 3: Getting Started
- Initial Configuration
- Configure the Steelhead Application
- A: EMC Regulatory Statements
- B: Waste Electrical and Electronic Equipment (WEEE) Statements
- C: Hardware Components
- D: Software Components
3-16
Getting Started
Configure the Steelhead Application
The next prompt is displayed:
Step 9: Would you like to activate the out-of-path
configuration? [no]
14. Answer no.
The wizard will allow you to confirm the settings you have selected. It
displays information similar to the following:
You have entered the following information:
1. Hostname: amnesiac
2. Use DHCP on primary interface: yes
3. Admin password: ******
4. SMTP server: exchange
5. Notification email address:
6. Set the primary interface speed: auto
7. Set the primary interface duplex: auto
8. Would you like to activate the in-path
configuration: no
9. Would you like to activate the out-of-path
configuration? no
To change an answer, enter the step number to return to.
Otherwise hit <enter> to save changes and exit.
15. If you are satisfied with the configuration settings you have selected, press
Enter. Otherwise, enter the number of the setting you want to change.
Refer to Table 3-1 for additional information about the configuration wizard.