Riverbed® Steelhead® RiOS® Application Installation and Getting Started Guide 2010-10
Table Of Contents
- 1: Overview
- 2: Hardware Installation
- 3: Getting Started
- Initial Configuration
- Configure the Steelhead Application
- A: EMC Regulatory Statements
- B: Waste Electrical and Electronic Equipment (WEEE) Statements
- C: Hardware Components
- D: Software Components
3-21
Getting Started
Configure the Steelhead Application
• If you are not a registered user of Riverbed products, go to the
Riverbed Licensing Portal at https://licensing.riverbed.com (which is
a public Web site).
Click Activate License. On the Activate Licenses page, enter your
license request key and click Submit. Then enter your company
information to complete your request.
Figure 3-2. Riverbed Licensing Portal
8. After your licenses are generated, they are displayed online and are then
emailed to you for reference.
9. Return to the Riverbed Steelhead Application to enter the install license
command to install each license. Copy and paste each license key at the
end this command.
amnesiac (config) # install license ?
<license key>
amnesiac (config) # install license XXX-SH10BASE-
YYYYZZZZ-1-XXXX-YYYY-ZZZZ
You must restart the optimization service for your
changes to take effect.
amnesiac (config) # install license XXX-SH10CIFS-
YYYYZZZZ-1-XXXX-YYYY-ZZZZ
You must restart the optimization service for your
changes to take effect.