Riverbed® Steelhead® RiOS® Application Installation and Getting Started Guide 2010-10
Table Of Contents
- 1: Overview
- 2: Hardware Installation
- 3: Getting Started
- Initial Configuration
- Configure the Steelhead Application
- A: EMC Regulatory Statements
- B: Waste Electrical and Electronic Equipment (WEEE) Statements
- C: Hardware Components
- D: Software Components
3-24
Getting Started
Configure the Steelhead Application
Figure 3-4. Configure > Maintenance > Licenses Page
2. Under License Request Key, type the token and click Generate License
Request Key.
This token is located on the HP License Registration card, which shipped
in the box with the Extended Services zl Module with Riverbed Application.
Note If you did not receive the HP License Registration Card, contact HP Support.
When you enter the token, the Steelhead Application generates and then
displays a license request key.
3. Complete one of the following to generate licenses, including the HPBASE
license and any flexible licenses needed for the Steelhead Application.