SBM powered by Microsoft Lync Administrator's Guide 2010-11

3-24

Manage and Monitor the HP SBM Locally

Access with the services tech Command

The following HP zl switch command gives you pass through access to the OS

running on the SBM:

hostzlswitch(config)# services <slot ID> tech

Note that the command must be entered from the switch’s global configuration

mode.

If you enter this command while the SBM is booting, you can monitor the

bootup process.If the SBM was not shutdown before the reboot, you will have

the option to boot it in Safe Mode.

After SBM is booted (whether or not in Safe Mode), you are placed in the

Special Administration Console (SAC). However, if the boot fails, you will see

the HP SBM Recovery Menu instead.

SAC

The SAC provides several commands to help you to recover the SBM and to

manage it remotely in a situation in which typical means of access have failed.

To access the SAC, enter this command from the global configuration mode

context of the HP zl switch CLI:

For example:

hostzlswitch(config)# services c tech

If the SBM is in the process of booting, the management session might hang.

Wait. As the SBM reboots, messages will begin to be displayed. If the SBM is

running, press

[Enter] until you see the SAC prompt.

Enter help or ? to see a list of available commands.

Syntax: services <slot ID> tech

Replace <slot ID> with the ID for the lower slot in which the

SBM is installed.