SBM powered by Microsoft Lync Administrator's Guide 2010-11

C-7

Command-Line Reference

Operator Context Commands

The Operator context features a limited number of commands that allow you

to see information about the SBM.

To access the Operator context, access the operator context of the CLI of the

HP zl switch in which the SBM is installed. Then enter the following command:

SBM Index and Name

To enter the CLI for the SBM’s ONE-App OS, you must either specify the

module’s product name or index number. The product name for the SBM is

always hp-sbm-branch.

The product index number is assigned to the SBM by the HP zl switch. This

index number varies, depending on whether or not any HP ONE Services zl

Modules are also installed in the host switch. The ONE Services zl Module is

a hardware platform that supports multiple products. (For a list of other

products that run on the ONE Services zl Module, visit the HP Web site at

www.hp.com/go/procurve.)

If there are no other types of ONE Services zl Modules installed in the switch,

the host switch assigns the SBM the index number 2.

If other types of ONE Services zl Modules are also installed in the switch, the

host switch assigns the SBM and each ONE Services zl product a different

index number, based on the order in which each one boots. For example, if

you install the SBM and boot it first, the host HP zl switch assigns it the index

number 2. However, if you install another ONE Services zl Module first and

boot it, the host switch will assign the product running on that module the

index number 2. If the SBM is installed next and booted, the HP zl switch will

assign it the index number 3.

Syntax:

services <slot ID> < <index> | name hp-sbm-branch >

Moves you to an OS context on the module.

Replace <slot ID> with the letter for the lower chassis slot

in which the module is installed.

Replace <index> with the index assigned to the SBM. If

you do not know this index, see the section below.