SBM powered by Microsoft Lync Administrator's Guide 2010-11

2-14
Complete the Setup Wizard
Configure the System Time
3. Set the SNTP mode:
hostzlswitch(config)# sntp unicast
4. Configure the SNTP server IP address (either the domain controller or an
SNTP server with the correct time):
5. Set the timezone:
6. If you are activating Daylight Saving Time on the SBM, you must activate
it on the HP zl switch:
7. Check the switch time and verify that it is correct:
hostzlswitch(config)# clock
8. Save the changes:
hostzlswitch(config)# write memory
9. After the switch has the correct time, reboot the SBM to apply the new
time:
hostzlswitch(config)# services <slot-ID> boot
Syntax: sntp server priority 1 <ip-address>
Replace <ip-address> with the reachable IP address of the
domain controller or SNTP server.
Syntax: time timezone <-780 - 840>
The switch calculates the time zone offset in minutes. For
example, type 60 for GMT +1.
Syntax: time daylight-time-rule < none | alaska | continental-us-and-canada |
middle-europe-and-portugal | southern-hemisphere | western-europe |
user-defined>
Select the region that applies to you.