SBM powered by Microsoft Lync Administrator's Guide 2010-11

2-15
Complete the Setup Wizard
Configure the System Time
Set the HP zl Switch Time Manually
Follow these steps:
1. Open a CLI management session with the HP zl switch and access the
global configuration context:
hostzlswitch# config
2. Set the date:
3. Set the time:
4. Set the timezone:
5. If you plan to activate Daylight Saving Time on the SBM, you must activate
it on the HP zl switch:
6. Check the switch time and verify that it is correct:
hostzlswitch(config)# clock
7. Save the changes:
hostzlswitch(config)# write memory
8. After the switch has the correct time, reboot the SBM to apply the new
time:
hostzlswitch(config)# services <slot-ID> boot
Syntax: clock set <DD:MM:YYYY>
Replace <DD:MM:YYYY> with the two-digit date, two-digit
month number, and four-digit year. For example, 05:05:2010
Syntax: clock set <HH:MM:SS>
Replace <HH:MM:SS> with the two-digit hour in the 24-hour
clock, two-digit minute, and two digit seconds. For example,
10:09:35.
Syntax: time timezone <-780 - 840>
The switch calculates the time zone offset in minutes. For
example, type 60 for GMT +1.
Syntax: time daylight-time-rule < none | alaska | continental-us-and-canada |
middle-europe-and-portugal | southern-hemisphere | western-europe |
user-defined>
Select the region that applies to you.