SBM powered by Microsoft Lync Administrator's Guide 2010-11

2-49
Complete the Setup Wizard
PSTN Configuration
4. The Interfaces section is automatically populated with an interface for
each interface on the card. Select the check boxes for the interfaces that
you want to use.
Make a note of the wanpipe ID for each interface; you might need this
information later for troubleshooting.
5. If you have multiple telephony cards, you can select others and then select
their interfaces.
Note When you select a second check box in the Select Boards section, you no longer
see the interfaces for the first board in the Select Interfaces for Board section.
However, the interfaces on the first board are still selected.
6. If you have only T1/E1 interfaces, move directly to the next step.
If you have FXS interfaces, you must fill in the Caller Name and Phone
Number for each. (Refer to your PSTN carrier for the correct phone
numbers.) Enter the full phone number, but not the E.164 number. For
example, if the E.164 number is [phone], you must enter 19165555555.
Figure 2-34. Setup Wizard—Hardware Configuration Page
7. Click Next.