SBM powered by Microsoft Lync Administrator's Guide 2010-11

2-63
Complete the Setup Wizard
PSTN Configuration
Figure 2-48. Setup Wizard—PSTN Config Window
7. Click Assigned board(s) and, if necessary, move the interface that connects
to the data device into the list of assigned interfaces. Click Save.
8. Click Save and close the PSTN Config window (click the X in the top right
corner).
9. To apply your changes, you must restart the gateway. Click Stop under
Media Gateway Status in the PSTN Configuration page. After the status
indicates that the gateways has stopped, click Start.
When you have finished your configuration, move to “Place PSTN Call” on
page 2-65.