SBM powered by Microsoft Lync™ Administrator's Guide 2011-11

3-36
Manage and Monitor the HP SBM Locally
Restoring and Replacing HP SBMs
6. Restore the SBM to factory defaults:
a. Access the SBM’s command prompt in one of two ways:
– Use the services <slot ID> tech command from the host zl switch
CLI to access the SAC. Then create a command prompt channel
and enter that channel. See “SAC” on page 3-27.
– Access the SBM via RDP (see “Remote Desktop Protocol (RDP)”
on page 3-20). Then open a command prompt, running it as an
administrator.
b. Enter this command to configure the SBM to boot to the recovery
console:
reagentc /boottore
c. Enter this command to restart the SBM:
shutdown /r /d 4:1
d. Wait a few moments. The SBM will then shutdown. The next steps
depend on how you accessed the command prompt:
– From the SAC—You will be returned to the SAC and warned
that the system is about to shutdown. Wait. As the SBM reboots,
messages will be displayed.
– Via RDP—Follow these steps:
i. You will lose your RDP connection. Open a management session
with in HP zl switch CLI.
ii. Move to the global configuration mode.
hostzlswitch# config
iii. Enter this command:
For example:
hostzlswitch(config)# services c tech
Syntax: services <slot ID> tech
Replace <slot ID> with the ID for the lower slot in which the
SBM is installed.