SBM powered by Microsoft Lync™ Administrator's Guide 2011-11

6-25
Troubleshooting
Regain Access to an SBM with Failed Network Functionality
16. Enter the password for the local Administrator.
17. The firewall helps to protect the SBM; however, you are disabling it for
now to ensure that you can gain access to the SBM (you can enable it
later):
hostswitch(hp-sbm-branch-C:win)# no firewall
18. Enable Remote Desktop:
hostswitch(hp-sbm-branch-C:win)# remote-desktop
Enable the Interface
19. Access the interface that you want to use and enable it. If you are resetting
the Ethernet interfaces, this interface is generally Ethernet Interface 2.
(You can also perform this procedure on the management interface.)
hostswitch(hp-sbm-branch-C:win:)# interface 2
hostswitch(hp-sbm-branch-C:win:eth-2)# enable
20. Check the status:
hostswitch(hp-sbm-branch-C:win:eth-2)# show interfaces
Note If the interface that you enabled is not up, it might be disabled on the switch.
Follow these steps:
1. Enter exit until you return to the HP zl switch CLI.
2. Enter interface <slot ID>2 enable (for Ethernet Interface 2) or interface <slot
ID>1 enable (for Ethernet Interface 1).
3. Return to the SBM OS CLI and check the interface status. The interface
that you enabled should be up.
Configure the Interface’s IP Settings
4. Set the IP address on the interface that you enabled. First, if necessary,
move to the interface configuration context. Then check the IP address:
hostswitch(hp-sbm-branch-C:eth-2)# show ip