SBM powered by Microsoft Lync™ Administrator's Guide 2011-11

2-6

Complete the Setup Wizard

Configure IP Settings

Your SBM might already have the correct IP settings either assigned to it by

the domain DHCP server or set during the initial installation. The SBM

requires:

 A valid IP address and default gateway address, which provide the SBM

with connectivity to the data center

 The domain DNS server IP address

The IP settings should typically be configured on the internal Ethernet inter-

face 2.

If the SBM already has these settings, you can immediately click Next and

move to “Configure the System Time” on page 2-12.

If you need to configure network settings, the sections below give guidelines;

when you are finished, click Next.

Caution Do not disable Ethernet interface 2. The SBM requires this interface to

communicate with the HP zl switch in which it is installed; disabling it causes

a fault condition.

In addition, you typically should not enable Ethernet interface 1. Doing so

without first ensuring that the data center has been properly configured can

cause the SBM’s services to fail.

Network Interfaces

The SBM has three network interfaces:

 Internal Ethernet Interface 1—The SBM's internal 10 Gigabit port 1, which

is disabled by default. You can use this interface as a backup connection

for Ethernet interface 2; however, data center engineers must complete

special DNS setup. Therefore, you should typically leave this interface

disabled.

 Internal Ethernet Interface 2— The SBM's internal 10 Gigabit port 2, used to

connect to the branch LAN (and from there to the data center over a WAN

connection). Typically, this is the interface that has the IP address associ-

ated with the SBM hostname.