SBM powered by Microsoft Lync™ Administrator's Guide 2011-11

C-18
Command-Line Reference
Interface Configuration Mode
shutdown
This command shuts down the SBM gracefully. You will be exited to the host
HP zl switch CLI. (To restart the SBM, you can enter services <slot ID> reload.)
Syntax: shutdown
Interface Configuration Mode
This section describes the commands that are available from the interface
configuration mode. Several general commands are available, as well as
commands specific to the interface, whether Internal Ethernet Port 1, Internal
Ethernet Port 2, or the Management Port. The commands are the same for
each interface.
disable
This command disables the interface.
Syntax: disable
enable
This command enables the interface.
Syntax: enable
ip address
This command sets the IP address for the interface.
Syntax: ip address <dhcp | <IP address> <subnet mask> >
You can either enter ip dhcp to have the interface obtain a dynamic IP address,
or you can specify a static IP address such as 10.1.1.30 255.255.255.0.