SBM powered by Microsoft Lync™ Administrator's Guide 2011-11

2-7
Complete the Setup Wizard
Configure IP Settings
 Management Interface—The 1 Gigabit Management port on the front of the
SBM, which you can connect directly to a management station. This
interface is intended to provide backup management access to the SBM,
typically for support purposes.
You configure the settings for each interface by clicking the corresponding
tab. You can set the basic settings manually, or the SBM can receive them using
DHCP. The basic settings include:
 IP address
 Subnet mask
 Default gateway
 DNS servers
Caution If you change the IP settings for the interface through which you are currently
connected to the SBM, you will lose contact with the SBM. You must contact
the SBM at the new IP address.