SBM powered by Microsoft Lync™ Administrator's Guide 2011-11

2-49
Complete the Setup Wizard
PSTN Configuration
Note When you select a second check box in the Select Boards section, you no longer
see the interfaces for the first board in the Select Interfaces for Board section.
However, the interfaces on the first board are still selected.
6. If you have only T1/E1 interfaces, move directly to the next step.
If you have FXS interfaces, you must fill in the Caller Name and Phone
Number for each. (Refer to your PSTN carrier for the correct phone
numbers.) Type the full phone number, but not the E.164 number. For
example, if the E.164 number is [phone], you must type 19165555555.
If you have FXO interfaces, you must fill in the Phone Number for each.
Again, type the full phone number but not the E.164 number.
It is recommended to assign FXO phone numbers to an automated atten-
dant or a receptionist, unless you have specific users that own inbound
calls on the FXO lines.
Figure 2-34. Setup Wizard—Hardware Configuration Page
7. Click Next.
8. Select your country, which automatically configures the SBM to use the
correct tones to detect dial tone, busy, and so forth.