SBM powered by Microsoft Lync Installation and Getting Started Guide 2010-11

1-7
Hardware Installation
Set the HP zl Switch Time
You should see the following output.
Figure 1-4. HP zl Switch CLI—show version Output
Set the HP zl Switch Time
The SBM gets the current time from the HP zl switch in which it is installed.
Important Because the domain join and other functions will fail unless the SBM time
matches the domain controller's, the HP zl switch must be set with the correct
time.
You can:
 Synchronize the HP zl switch and the domain controller time using SNTP
(recommended for a permanent installation)
 Set the HP zl switch time manually
Synchronize the HP zl Switch Using SNTP
To synchronize the HP zl switch time using SNTP, follow these steps:
1. Open a CLI management session with the HP zl switch and access the
global configuration context:
hostzlswitch# config
2. Enable SNTP:
hostzlswitch(config)# timesync sntp
3. Set the SNTP mode:
hostzlswitch(config)# sntp unicast