SBM powered by Microsoft Lync Installation and Getting Started Guide 2010-11

1-8
Hardware Installation
Set the HP zl Switch Time
4. Configure the SNTP server IP address (either the domain controller or an
SNTP server with the correct time):
5. Set the timezone:
6. If you plan to activate Daylight Saving Time on the SBM, you must activate
it on the HP zl switch:
Caution If you set Daylight Savings Time on the SBM but not on the switch, the SBM
will become unreliable until this setting is reconciled. If you experience this
problem, first reconcile the setting on the HP zl switch and the SBM. Then
power cycle the SBM at least twice.
7. Check the switch time and verify that it is correct:
hostzlswitch(config)# clock
8. Save the changes:
hostzlswitch(config)# write memory
Set the HP zl Switch Time Manually
Follow these steps:
1. Open a CLI management session with the HP zl switch and access the
global configuration context:
hostzlswitch# config
Syntax: sntp server priority 1 <ip-address>
Replace <ip-address> with the reachable IP address of the
domain controller or SNTP server.
Syntax: time timezone <-780 - 840>
The switch calculates the time zone offset in minutes. For
example, to specify GMT +1, type 60.
Syntax: time daylight-time-rule < none | alaska | continental-us-and-canada |
middle-europe-and-portugal | southern-hemisphere | western-europe |
user-defined>
Select the region that applies to you.