SBM powered by Microsoft Lync Installation and Getting Started Guide 2010-11

1-11
Hardware Installation
Install the SBM
The SBM is hot-swappable; that is, the HP zl switch can be powered on or off
when you install the module within it. The following procedure assumes the
switch is powered on.
Installation Procedure
Note Install your HP PCIe telephony cards on the SBM before you install the module
into the switch.
1. Use a Torx T-10 or flat-bladed screwdriver to unscrew the screws in the
cover plates over the slots where you will install the SBM. Note that the
module occupies two slots, one on top of the other. Remove the covers,
and store the cover plates for possible future use.
2. Hold the module by its bulkhead, taking care not to touch the metal
connectors or components on the board.
3. Open the extractor handles.
4. Insert the module, aligning with the guides in the slots, and slide it into
the slots until it is fully inserted.
5. Once the module is fully inserted, use the extractor handles to seat it
completely.
6. Tighten the screws.