SBM powered by Microsoft Lync Installation and Getting Started Guide 2010-11

1-2

Hardware Installation

Overview of the SBM

Table 1-1. Installation Process

SBM Hardware

The SBM is an HP AllianceONE application running on an HP AllianceONE

Extended Services zl Module. The module is installed in an HP 5400zl or 8200zl

Series switch at the branch office.

Note The maximum number of ONE Services zl Modules that can be installed in a

switch chassis depends on the switch model. See Table 1-6 on page 1-14 for

details.

For information on which HP zl switch software version is required, see

Appendix D in the Web version of this document at www.hp.com/networking/

manuals, or see the Read Me First shipped with the module.

For a description of the front panel buttons and LEDs, which are identified in

the figure below, see Table C-1 on page C-2 in the Web version of this document

at www.hp.com/networking/manuals.

Estimated Time Task Reference

25 minutes Install the HP Switch 5406zl (if not

already installed)

Installation and Getting Started Guide for the HP ProCurve

Series 5400zl Switches shipped with your equipment

8 minutes Update the HP zl switch software “Update the Switch Software” on page 1-5

2 minutes Set the HP zl switch time “Set the HP zl Switch Time” on page 1-7

5 minutes Install PCIe cards in the SBM PCIe Analog Card (FXO or FXS) and Digital Card Installation

Instructions shipped with these cards

5 minutes Install the SBM in the HP zl switch “Install the SBM” on page 1-10

15 minutes Wait for the initial bootup “Install the SBM” on page 1-10

10 minutes Complete initial setup in the HP zl

switch and SBM CLI

Chapter 2: “Getting Started”

30 minutes Complete the SBM Setup Wizard HP Survivable Branch Communication zl Module (SBM)

Administrator’s Guide