Secure Access Configuration Guide For Wireless Clients Part Two: Wireless Data Privacy and Monitored Logon 2003-03

Figure 6.15 – System Authentication Policy
6) On the ACS, configure the Authenticated Access Policy to allow clients to
use Real IP addresses (via DHCP).
a. Refer to Configuring Scenario 2 in Part One of this guide to configure the
Authenticated Access Policy to allow clients to use Real IP addresses.
b. On the ACS, browse to Status -> Client Status and click Refresh User
Rights Now.
7) On the AP 420, configure Dynamic WEP/802.1x and add the RADIUS
Server IP address and RADIUS Key.
a. Configure Dynamic WEP/802.1x and add the RADIUS Server IP address
and RADIUS Key.
HP ProCurve Access Point 420# configure
HP ProCurve Access Point 420(config)# int wireless g
Enter Wireless configuration commands, one per line.
HP ProCurve Access Point 420(if-wireless g)# security-suite 5
HP ProCurve Access Point 420(if-wireless g)#end
HP ProCurve Access Point 420(config)# radius-server address
10.24.3.10
HP ProCurve Access Point 420(config)# radius-server key secret
HP ProCurve Access Point 420(config)# exit
© Copyright 2005 Hewlett-Packard Company, LP. 55