Secure Access Configuration Guide For Wireless Clients Part Two: Wireless Data Privacy and Monitored Logon 2003-03

• Enable the Access Point radio
• Wireless SSID (x52800cb2) and channel (6).
HP ProCurve Access Point 420# configure
Enter configuration commands, one per line. End with CTRL/Z
HP ProCurve Access Point 420(config)# int eth
Enter Ethernet configuration commands, one per line.
HP ProCurve Access Point 420(if-ethernet)# no ip dhcp
HP ProCurve Access Point 420(if-ethernet)# ip addr 10.24.3.62
255.255.255.0 10.24.3.1
HP ProCurve Access Point 420(if-ethernet)# end
HP ProCurve Access Point 420(config)# int wireless g
Enter Wireless configuration commands, one per line.
HP ProCurve Access Point 420(if-wireless g)# no shut
HP ProCurve Access Point 420(if-wireless g)# ssid x52800cb2
HP ProCurve Access Point 420(if-wireless g)# channel 6
2. Configuring the ACS to recognize the AP 420 as “Network Equipment”
Connect the AP 420 to the network (see Figure A) and open the Web browser
management interface to the ACS. Enter the username and password (default
shown here) of the ACS:
Username: admin
Password: admin
a) Browse to Status -> Client Status and copy the MAC address of the AP
420.
Figure B – Client Status Page
© Copyright 2005 Hewlett-Packard Company, LP. 6