TMS zl Management and Configuration Guide ST.1.0.090213

D-54
Troubleshooting
Troubleshooting the TMS zl Module in Routing Mode
If you want to disable IPS only for a particular device, create a new access
policy that affects only that device. Clear the Enable IPS on this Policy option
so that IPS does not check the traffic that matches this access policy.
To disable the signature itself, complete the following steps:
1. Click Intrusion Prevention > Signatures.
2. Click View.
Figure D-11. Intrusion Prevention > Signatures > View Window
3. Locate the signature in the list and clear the Enable option.
4. Click Save.
You can also disable a signature from the CLI. Enter:
hostswitch(tms-module-C:config)# ips signatures
<Signature_Family> <Signature_ID> disable