TMS zl Management and Configuration Guide ST.1.0.090213

2-9
Initial Setup in Routing Mode
Deploying the TMS zl Module in Routing Mode
Figure 2-4. Zones Inside the TMS zl Module
Figure 2-4 shows the zones and VLANs from Figure 2-3 as they might be
deployed in a network. Physical port 1, the data port, is tagged for all
TMS VLANs. Port 2 will forward HA traffic to the other member of the cluster
(if configured), but the IP address for port 2 is not in the Self zone. Port 2 is
an untagged member of the HA VLAN, if HA is configured.
If you would like the TMS zl Module to check traffic from a VLAN that is not
configured on the module’s host switch, you must configure the module as the
next-hop router for that VLAN.