TMS zl Management and Configuration Guide ST.1.0.090213

2-12
Initial Setup in Routing Mode
Deploying the TMS zl Module in Routing Mode
The host switch must have an IP address on a TMS VLAN so that the
module can route non-TMS VLAN traffic to it. If the switch is also
routing traffic to the Internet, you can use the Internet TMS VLAN for
this purpose. You could also use the management VLAN, but this
would place the non-TMS VLANs in the management zone, which is
undesirable.
3. Determine whether or not to disable routing on the switch:
• Disable routing if the switch only has an IP address on its management
VLAN.
• Leave routing enabled in these circumstances:
– The switch must route traffic for non-TMS VLANs.
– The switch will route external traffic for the TMS zl Module.