TMS zl Management and Configuration Guide ST.1.0.090213

2-13
Initial Setup in Routing Mode
Initial Setup
Initial Setup
The TMS zl Module must be installed in one of the following chassis:
■ HP ProCurve Series 5400zl switch
■ HP ProCurve 8212zl switch
Consult the ProCurve Switch zl Module Installation Guide or “Hardware
Overview” in Chapter 1: “Overview“ for information on how to properly install
the module in the switch chassis.
Access the TMS zl Module’s CLI
To begin the initial setup, you must first access the TMS zl Module through
the host switch’s command-line interface (CLI), using one of the following
access methods:
■ Serial session
■ Telnet session
■ Secure Shell (SSH) session
To establish a console connection with the switch, use the serial cable that
was shipped with the switch to connect a workstation to the switch. Then, run
terminal session software such as Tera Term or HyperTerminal on your
workstation, and set the following parameters for the session:
■ Baud rate = 9600
■ Parity = None
■ Data bits = 8
■ Stop bits = 1
■ Flow control = None
If you are prompted for a password when you access the host switch’s CLI,
enter the password for the manager user.