TMS zl Management and Configuration Guide ST.1.0.090213

2-29

Initial Setup in Routing Mode

Configure Management Access

Before you can access the Web browser interface and begin configuring the

TMS zl Module, you must access the Product OS context and perform some

initial tasks.

■ Enable management access on a zone

■ Optionally, configure a priority VLAN

■ Associate a VLAN with the zone

■ Configure a static IP address for the VLAN

■ Configure the default gateway

The step-by-step instructions that follow show you how to set up management

access to the TMS zl Module using the example setup shown in Figure 2-10.

Figure 2-10. Initial Setup Example

The example in Figure 2-10 shows a TMS zl Module in slot C of an HP Pro-

Curve 5406zl switch. VLAN 5 is configured on the switch and has the IP

address of 10.1.5.0/24. The management workstation is in VLAN 5, as is the

internal interface of the module’s default gateway.