TMS zl Management and Configuration Guide ST.1.0.090213

2-33
Initial Setup in Routing Mode
Configure Management Access
Figure 2-11. Routing Internal-to-External Traffic through the Module
• If the module’s host switch is the default gateway, this VLAN is
typically the VLAN on which the host switch connects to the external
router. Make sure that the switch has an IP address on that VLAN.
For example, in Figure 2-12, the host switch connects to the external
router on VLAN99 (subnet 10.1.99.0/24). Both the host switch and the
external router have IP addresses on this subnet (10.1.99.98 on the
switch and 10.1.99.101 on the router). The TMS zl Module also has an
IP address, which you will configure in the next step.
Figure 2-12. Routing Internal-to-External Traffic through the Host Switch
• If a core switch is the default gateway, this VLAN is typically the VLAN
on which the module’s host switch connects to the core switch.
If necessary, configure the VLAN on the host switch so that the TMS zl
Module can reach the default gateway on the correct VLAN.