TMS zl Management and Configuration Guide ST.1.0.090213

2-38
Initial Setup in Routing Mode
Configure Management Access
ii. Ping the default gateway.
hostswitch (tms-module-C:config)# ping <default
gateway>
For example, you might enter:
hostswitch (tms-module-C:config)# ping
10.1.99.101
PING 10.1.99.101 (10.1.99.101) 56(84) bytes of
data.
64 bytes from 10.1.99.101: icmp_seq=1 ttl=255
time=1.54 ms
64 bytes from 10.1.99.101: icmp_seq=2 ttl=255
time=0.515 ms
64 bytes from 10.1.99.101: icmp_seq=3 ttl=255
time=0.526 ms
11. Save the configuration on the TMS zl Module:
Note For the TMS zl Module, the write memory command saves the configurations
that have been made in all contexts.
12. On the default gateway (the router or routing switch), create a route or
routes to the TMS VLANs. The routes’ next hop should be the TMS zl
Module’s IP address on the VLAN that you just added.
See Appendix A: “Threat Management Services zl Module Command-Line
Reference” for a complete list of CLI commands for the TMS zl Module.
extended options • schedule <schedule object>
This command must be entered before all other
extended options commands.
•log
•ips-off
• enable
• disable
• insert-at <position>
• update-at < position | id <policy ID> >
You can use any combination of the extra options—as
many or as few as you like.
Syntax: write memory
Saves the running-config to the startup-config.
Parameter Options