TMS zl Management and Configuration Guide ST.1.0.090213

2-48
Initial Setup in Routing Mode
Configure Management Access
Network Interfaces
Name Name of the TMS VLAN.
Network > Settings > Zones
See “Plan the Zones” on page 2-7.
Status UP or DOWN; describes whether the
interface is functioning
n/a
IP/Mask The IP address and network mask for the
TMS zl Module's interface on the
TMS VLAN
Network > Settings > Zones
See “Plan the Zones” on page 2-7.
Received Number of kilobytes per second that are
being received on the interface
n/a
Sent Number of kilobytes per second that are
being sent on the interface
n/a
Firewall
Zone Name of the firewall zone n/a
Connections Number of connections into and out of the
zone. See the “Note” that follows this table.
n/a
Limit Maximum number of connections permitted
for that zone
Firewall > Settings > Connection Allocations
See “Connection Reservations” in Chapter 4:
“Firewall.”
Usage Percentage of the connection limit that is
being used currently
n/a
Attempted
Connections
Number of connection attempts per second
for the entire firewall
n/a
Intrusion Prevention
Packets Inspected Number of packets per second that the IDS
is currently inspecting
n/a
Packets Blocked Number of packets per second that the IPS
is currently blocking (Action: Block the
traffic)
Intrusion Prevention > Settings > Actions
“Configuring IPS Actions (Routing Mode Only)” in
Chapter 6: “Intrusion Detection and Prevention.”
Sessions
Terminated
Number of sessions per second that the IPS
is currently terminating (Action: Terminate
the session)
Intrusion Prevention > Settings > Actions
“Configuring IPS Actions (Routing Mode Only)” in
Chapter 6: “Intrusion Detection and Prevention.”
Signatures version The version of the signature file that the
module is using to filter traffic.
Intrusion Prevention > Signatures
“Configuring Signature Detection” in Chapter 6:
“Intrusion Detection and Prevention.”
Field Description How to Configure