TMS zl Management and Configuration Guide ST.1.0.090213

2-53
Initial Setup in Routing Mode
Configure Management Access
Typically, the TMS zl Module connects to its default gateway on a VLAN in the
External zone. However, you may have associated the VLAN with a different
zone. Therefore, you should add another VLAN to the module for the connec-
tion to the default gateway.
Follow these steps:
1. Determine the VLAN on which the TMS zl Module connects to its default
gateway. See “Configure Management Access” on page 2-29 to see how to
determine the default gateway.
2. Select Network > Routing > Static Routes.
3. Click Add static route.
Figure 2-24. Add Static Route Window
4. For Destination Type, select Default Gateway.
5. For Gateway Address, type the IP address of the default gateway.
6. For Metric, type 0.
7. Click OK.
8. Click Save.