TMS zl Management and Configuration Guide ST.1.0.090213

2-55
Initial Setup in Routing Mode
Configure Management Access
2. From the User list, select manager (read/write) or operator (read only).
3. Type the Old password.
Note The default passwords are: manager = procurve; operator = operator.
4. For New password and Confirm new password, type a new password for the
user. The new password cannot have more than 14 characters.
5. Click Apply My Changes.
Note The operator cannot change passwords. Operator is read-only in all windows.
6. Click Save.
High Availability
Even if you do not plan to configure the module for high availability (HA), you
should change the HA VLAN from the default to prevent unwanted multicast
traffic from occupying the firewall’s resources. If you DO plan to configure
the module for HA, first configure the module’s other settings, then
configure HA.
If you do plan to configure the module for HA, see Chapter 8: “High
Availability.”
If you to not plan to configure the module for HA, complete the following steps:
1. Select System > Settings > High Availability.
2. Verify that for Cluster Scheme, None is selected.
3. Under HA IP Configuration, configure the following:
a. For VLAN ID, type the VLAN number of a VLAN that is not used. This
VLAN must be configured on the host switch.
b. For IP Address and Subnet Mask, type an IP address and subnet mask
on that VLAN.
4. Click Apply My Changes.
5. Click Save.
Configure DNS
To configure the DNS server settings, complete the following steps:
1. Select Network > Settings > General.