TMS zl Management and Configuration Guide ST.1.0.090213

2-62
Initial Setup in Routing Mode
Configure Management Access
Configure SNMP Traps
SNMP traps are unsolicited messages that are sent by managed devices to alert
you about specific events. For example, you can use PCM+ to manage the
TMS zl Module by specifying PCM+ as a trap destination.
The TMS zl Module supports the standard MIB-II, the IF-MIB, and a proprie-
tary MIB that is particular to the operation of the TMS zl Module.
Note If you configure SNMP traps from the PCM+ interface instead of from the
TMS zl Module interface, the module will send only the MIB-II and IF-MIB
traps to the PCM+ server, not the proprietary MIB traps. The proprietary MIB
can be found in the help files on the module.
To configure SNMP traps, select System > Logging and click the SNMP Traps tab.
Figure 2-35. System > Logging > SNMP Traps Window
To enable SNMP traps, do one or both of the following:
■ Select the Enable SNMPv2 traps check box.
■ Select the Enable SNMPv3 traps check box.
To add an SNMPv2 trap destination (such as PCM+), complete the following
steps:
1. Under Enable SNMPv2 traps, click Add another destination. The Add SNMPv2
Destination window is displayed.