TMS zl Management and Configuration Guide ST.1.0.090213

2-63
Initial Setup in Routing Mode
Configure Management Access
Figure 2-36. Add SNMPv2 Destination Window
2. For Server Address, type the IP address or FQDN of the SNMP server. For
example, if you are using PCM+, you would enter the IP address or FQDN
of the server running PCM+.
3. For Community Name, type the read-write (unrestricted) community name.
You must enter the read-write community name that is configured on the
SNMP server.
4. Click OK.
5. Click Save.
To add an SNMPv3 trap destination (such as PCM+), complete the following
steps:
1. Under Enable SNMPv3 traps, click Add another destination. The Add SNMPv3
Destination window is displayed.
Figure 2-37. Add SNMPv3 Destination Window