TMS zl Management and Configuration Guide ST.1.0.090213

2-64
Initial Setup in Routing Mode
Configure Management Access
2. For Server Address, type the IP address or FQDN of an SNMPv3 server.
For example, if you are using PCM+, you would enter the IP address or
FQDN of the server running PCM+.
3. For Username, type the SNMPv3 username for an account on the server.
This must match the username configured on the SNMP server (such as
PCM+).
4. For Auth Passphrase, type the authentication passphrase for the account
on the server. This must match the authentication passphrase configured
on the SNMP server (such as PCM+).
5. For Auth Protocol, select the authentication protocol used on the SNMPv3
server: MD5 or SHA. Again, this must match the setting configured on the
SNMP server (such as PCM+).
6. Optionally, for Privacy Passphrase, type the privacy passphrase for the
account on the SNMP server, if this setting is configured on the server.
7. Optionally, for Privacy Protocol, select the privacy protocol used on the
server: DES or AES. You would configure a privacy protocol if one is
configured on the SNMP server.
8. Click OK.
9. Click Save.
Configure SNMP
The TMS zl Module allows some remote management through SNMPv1/v2c or
SNMPv3. For example, you can configure SNMP so that the module can be
managed by PCM+. If you are going to allow remote management through
SNMP, make sure that you configure the parameters on the TMS zl Module to
match those configured on the SNMP server.
To configure SNMP settings, select System > Settings and click the SNMP tab.