TMS zl Management and Configuration Guide ST.1.0.090213

2-68
Initial Setup in Routing Mode
Configure Management Access
Figure 2-42. Add VLAN Association Window
3. From the Zone list, select a zone.
4. From the VLAN list, select a VLAN. The VLANs displayed in the list are
VLANs that already exist on the switch and have not yet been associated
with a zone.
5. Optionally, select the Allow switch to have IP address on this VLAN
check box.
Note It is recommended that the host switch not have an IP address on a TMS VLAN
when Layer 3 routing is enabled on the host switch. If you want the traffic
checked by the module, inter-VLAN traffic must be routed through the TMS zl
Module instead of being routed directly by the host switch.
6. Under IP Setting, select Static or Dynamic.