TMS zl Management and Configuration Guide ST.1.0.090213

2-70
Initial Setup in Routing Mode
Configure Management Access
1. Select Network > Settings and click the DHCP Relay tab.
Figure 2-43. Network > Settings > DHCP Relay Window
2. Select the Enable DHCP Relay check box.
3. For DHCP Server, type the IP address of the DHCP server.
4. The Network > Settings > DHCP Relay window lists all of your TMS VLANs.
Next to each VLAN for which you want to enable DHCP relay, select the
Enable DHCP Relay check box.
5. Click Apply My Changes.
6. Click Save.
If you enable DHCP relay, you may need to create firewall access policies to
permit the DHCP traffic. The figure below shows that four access polices are
needed for DHCP relay from one zone to another. (If the client and server are
in the same zone but in different TMS VLANs, you would still need to configure
these access policies.)
1. Client to Self — Permit bootps
2. Self to server — Permit bootps
3. Server to Self — Permit bootps
4. Self to client — Permit bootpc